Note: You are reading this message either because you can not see our css files, or because you do not have a standards-compliant browser.

LOGO: Journal of Cotton Science


Second Stage Lint Cleaning System PM2.5 Emission Factors and Rates for Cotton Gins: Method 201A Combination PM10 and PM2.5 Sizing Cyclones

Authors: J. Clif Boykin, Michael D. Buser, Derek P. Whitelock, and Gregory A. Holt
Pages: 380-390
Engineering and Ginning

This report is part of a project to characterize cotton gin emissions from the standpoint of stack sampling. In 2006, EPA finalized a more stringent standard for particulate matter with nominal diameter less than or equal to 2.5 µm (PM2.5). This created an urgent need to collect additional cotton gin emissions data to address current regulatory issues, because current EPA AP-42 cotton gin PM2.5 emission factors did not exist. The objective of this study was the development of PM2.5 emission factors for cotton gin 2nd stage lint cleaning systems based on the EPA-approved stack sampling methodology, Method 201A. The project plan included sampling seven cotton gins across the cotton belt. Key factors for selecting specific cotton gins included: 1) facility location (geographically diverse), 2) industry representative production capacity, 3) typical processing systems, and 4) equipped with properly designed and maintained 1D3D cyclones. Four of the seven gins were equipped with 2nd stage lint cleaning systems where the exhaust airstreams were not combined with 1st stage lint cleaning systems. In terms of capacity, the four gins were typical of the industry; averaging 27.3 bales/h during testing. Some test runs were excluded from the test averages because they failed to meet EPA Method 201A test criteria. Also, other test runs included in the analyses had cotton lint fibers that collected in the ≤ 10 µm and/or ≤ 2.5 µm samples. This larger lint material can impact the reported emissions data, but EPA Method 201A does not suggest methods to account for these anomalies. Average measured 2nd stage lint cleaning system PM2.5 emission factor based on the four tests (nine total test runs) was 0.0051 kg/227-kg bale (0.011 lb/500-lb bale). The 2nd stage lint cleaning system average emission factors for PM10 and total particulate were 0.022 kg/bale (0.048 lb/bale) and 0.033 kg/bale (0.074 lb/bale), respectively. The 2nd stage lint cleaning system PM2.5 emission rate from test averages ranged from 0.067 to 0.38 kg/h (0.15-0.83 lb/h). System average PM10 and total particulate emission factors were lower than those currently published in EPA AP-42. The ratios of 2nd stage lint cleaning system PM2.5 to total particulate, PM2.5 to PM10, and PM10 to total particulate were 15.2, 23.1, and 65.7%, respectively.